How To Use Knuckle And Fingertip Bandages

A cutting on your fingertip can be a real pain! It's the most likely identify to become a newspaper cut. Or maybe y'all've pulled off a hangnail and taken the surrounding peel with it, leaving an open sore. Unfortunately, your typical Ring-Assist is not ideal to protect your fingertip. Information technology creates a sort of "funnel" which collects dirt, water, and droppings. This dirt and debris are then allowed to penetrate under the cotton pad and onto the wound since the meridian of the cast isn't well adhered to the finger.

Thankfully, a Rough-and-tumble has been specifically designed to have care of your fingertip. Its hourglass or butterfly shape allows information technology to better cover the finger and muffle whatsoever edges, keeping the cut condom from infection.

How to apply a finger cast

1. Launder your hands – If water and soap isn't available and yous don't take gloves, practice your all-time to clean your hands and use sand sanitizer if it's available.
2. Make clean and disinfect the wound
3. Open the bandage wrapper
4. Remove one side of the protective backing
5. Utilise an antibody ointment (similar Neosporin) to the cotton wool pad (non required, but suggested)
6. Utilise the wide portion (butterfly fly) of the bandage to the fingernail side of the fingertip so that approximately half of the bandage extends beyond the fingertip.
7. Wrap exposed portion of the "wing" onto the finger, making sure that the pad is fully covering your wound
8. Remove the second piece of protective backing
9. Wrap the other terminate of the "wing" effectually the finger. You should all the same have one-half of the bandage sticking up beyond your fingertip.
10. Yous can at present wrap the far end of the bandage over the top of the fingertip
11. Wrap the 2 ends of the remaining "wing" over the first

Pro tip: If y'all piece of work in a dirty or wet environment, or plan to be in one, employ a finger cover or "rubber" to protect your finger. Apply at the beginning of your chore or day, and toss it when information technology's done.

How to DIY a fingertip bandage

If yous don't accept a fingertip cast on mitt, or if y'all need a larger bandage than your typical butterfly style, you tin can DIY your own.

Method 1: Cross method

Employ a typical strip bandage (1″x3″) for this method.

1. Cutting both ends lengthwise from tip to a little before the cotton pad. You lot desire to maintain a little scrap of the adhesive portion to keep anything from getting under the pad.
2. Remove the protective backing
3. Apply the pad to the cut keeping the Rough-and-tumble parallel to the finger
4. Cantankerous the strips on i side, making a sort-of "10". This pulls the edges of the bandage near the pad closer to the finger.
5. Exercise the aforementioned thing on the contrary side with the remaining two legs

Method 2: Butterfly method

This will need to be done with a larger cast than your typical i″x3″ since nosotros'll be cut the cast to look similar in shape to a shop-bought fingertip cast.

1. Cutting a notch out of the long side of a Band-aid on either side. Start off with a small notch, test it, and adjust every bit needed. Keeping the protective backing on will make this much easier.
2. Utilize information technology to your fingertip similar to the steps for a shop bought fingertip bandage.

What'south your feel with fingertip bandages? Let the states know in the comments below.

Source: https://medkitauthority.com/fingertip-bandage/

Share this post